Power Source Circuit

DOOR LOCK: WIRELESS DOOR LOCK CONTROL SYSTEM: Power Source Circuit
- Power Source Circuit

DESCRIPTION

The certification ECU provides power for the door control receiver operation.

WIRING DIAGRAM





INSPECTION PROCEDURE

PROCEDURE

1. INSPECT CERTIFICATION ECU (+B TERMINAL)

(a) Measure the voltage according to value(s) in the table below.





Standard voltage:





NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR
OK -- Continue to next step.

2. INSPECT CERTIFICATION ECU (RC0 TERMINAL)

(a) Measure the voltage according to the value(s) in the table below.





Standard voltage:





OK -- CHECK HARNESS AND CONNECTOR (CERTIFICATION ECU - DOOR CONTROL RECEIVER)
NG -- Continue to next step.

3. CHECK HARNESS AND CONNECTOR (CERTIFICATION ECU - BATTERY - BODY GROUND)

(a) Disconnect the E13 certification ECU connector.

(b) Measure the voltage and resistance according to the value(s) in the table below.





Standard:





NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR

OK -- REPLACE CERTIFICATION ECU

4. CHECK HARNESS AND CONNECTOR (CERTIFICATION ECU - DOOR CONTROL RECEIVER)

(a) Disconnect the M5 door control receiver connector.





(b) Measure the resistance according to the value(s) in the table below.

Standard resistance:





NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR
OK -- Continue to next step.

5. CHECK HARNESS AND CONNECTOR (BODY GROUND)

(a) Measure the resistance according to the value(s) in the table below.





Standard resistance:





NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR

OK -- PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE