Installation

3UZ-FE ENGINE MECHANICAL: DRIVE BELT: INSTALLATION

INSTALLATION

1. INSTALL FAN AND GENERATOR V BELT





(a) Set the V-belt to everything except the No. 2 idler pulley, as shown in the illustration.
(b) Loosen the V-belt by turning the belt tensioner counterclockwise.
(c) Then set the V-belt to the idler pulley.





(d) After a new belt has been installed, check that the mark is within the A range shown in the illustration.
2. INSTALL NO. 1 AIR CLEANER INLET
(a) Install the air cleaner inlet with the bolt.
Torque: 5.0 Nm (51 kgf-cm, 44 in-lbf)