Generator Brace Replacement

Generator Brace Replacement (L26) (3.8L)

Removal Procedure




1. Remove the generator rear brace nut (5).
2. Remove the generator rear brace bolt (3).
3. Remove the generator rear brace (4).

Installation Procedure




1. Install the generator rear brace (4).
2. Install the generator rear brace bolt (3).
3. Install the generator rear brace nut (5).

Caution: Refer to Fastener Caution (Fastener Caution).

4. Tighten the generator bolts in the order described. The following is a mandatory torque sequence:

1. Tighten the generator rear brace bolt (3) to 50 Nm (37 lb ft).
2. Tighten the generator rear brace nut (5) to 50 Nm (37 lb ft).