Bracket for Vehicle Electrical System Control Module -J519-, REMOVING AND INSTALLING: Removing

WARNING: This page is about a different car, the 2025 Volkswagen Jetta. However, it is still accessible from the selected car via links, so may be relevant.

-- Disconnect the Battery -A-. Refer to BATTERY, DISCONNECTING AND CONNECTING .

-- Remove the instrument panel. Refer to INSTRUMENT PANEL, REMOVING AND INSTALLING .

-- Cut the cable tie -arrow-.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Disengage the Fuse Panel C -SC- and push it to the side. Refer to RELAY AND FUSE PANEL BEHIND INSTRUMENT PANEL ON DRIVER SIDE, REMOVING AND INSTALLING .

-- Release and disconnect the connector from the Front Parking Aid Warning Buzzer -H22-.

-- Release and disconnect the connector on the Vehicle Electrical System Control Module -J519-. Refer to Vehicle Electrical System Control Module -J519-, REMOVING AND INSTALLING .

-- Remove the diagnostic connector by releasing the locking mechanism on the bracket and removing the bracket outward.

-- Remove the bolts -2 and 3- and -6-.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Push the bracket -1- far enough forward from the instrument panel crossmember until the alignment pins -4- and -5- are disengaged.

-- Cut the cable ties -arrows-.

-- Free up the wiring harness on the mount.

-- Remove the bracket to the vehicle interior.