Overview - Assembly Mounts

WARNING: This page is about a different car, the 2025 Volkswagen Jetta. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Exploded View Of Engine Assembly Mounts

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

Engine Support
- Removing and Installing. Refer to ENGINE SUPPORT, REMOVING AND INSTALLING .
Bolt
- Always replace after removing
- Tightening specification, sequence and allocation. Refer to Fig 2.
Engine Mount
- With support arm
- Removing and Installing. Refer to ENGINE MOUNT, REMOVING AND INSTALLING .
Bolt
- Always replace after removing
- 20 Nm +90°
Double Bolt
- Always replace after removing
- 40 Nm +90°
Bolt
- Always replace after removing
- 40 Nm +90°
Bolt
- Always replace after removing
- 60 Nm +90°
Pendulum Support
- Removing and Installing. Refer to PENDULUM SUPPORT, REMOVING AND INSTALLING .
- Tightening sequence and tightening specification. Refer to Fig 3.
Bolt
- Always replace after removing
- Tightening specification and sequence. Refer to Fig 3.
Bolt
- Always replace after removing
- Tightening specification and sequence. Refer to Fig 3.
Bolt
- Always replace after removing
- Tightening specification and sequence. Refer to Fig 3.
Bolts
- Always replace after removing
- 60 Nm +90°
Bolts
- Always replace after removing
- 50 Nm + 90°
Transmission Mount
- With support arm
- Removing and Installing. Refer to TRANSMISSION MOUNT, REMOVING AND INSTALLING .
Bolt
- Always replace after removing
- 50 Nm + 90°

Engine Support - Tightening Specification and Sequence

Fig 2: Engine Support Bolts Tightening Sequence

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

NOTE:

Replace the bolts that were tightened with an additional turn.

-- Tighten the bolts in the steps in the sequence shown:

Step	Bolts	Tightening Specification/Additional Turn
1.	-1 to 3-	40 Nm
2.	-1 to 3-	90° additional turn

Pendulum support threaded connection

Fig 3: Engine Support Component Location

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

NOTE:

Replace bolts that were tightened with an additional turn after removing them.

-- Tighten the bolts in the steps in the sequence shown:

Tightening Specifications

Step	Bolts	Tightening Specification/Additional Turn
1	-2 and 3-	50 Nm
2	-1-	130 Nm
3	-1 to 3-	90° additional turn