Seat Adjustment Control Module, Removing And Installing: Removing
WARNING: This page is about a different car, the 2025 Audi S3, 2025 Audi RS 3, and 2025 Audi A3 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
If the Memory Seat/Steering Column Adjustment Control Module -J136- is replaced, perform the test plan for replacing the control module:
-- Perform the "control module, replacing" function using the Vehicle Diagnostic Tester. Refer to Diagnostic Entries .
Continuation
-- Move the front seat as far back and as high as possible.
-- Open the tabs -arrows-.
-- Remove the control module -1-.
-- Disconnect the connectors -2-.
Remove the control module bracket:
-- Press out the pin -arrow-.
-- Remove the pin -arrow- that was pressed out.
-- Unclip the bracket support -1-.
-- Disengage the bracket -1- and remove.