Battery, Disconnecting And Connecting
The Battery Monitoring Control Module -J367- will be called battery monitoring control module in the information that follows.
Battery -A- will be called battery in the information that follows.
Disconnecting
-- End the drive ready mode.
-- Switch off the ignition and electrical equipment.
-- Place the vehicle key and other start authorization systems (such as smartphones) outside of the vehicle interior.
-- Open the negative terminal cover above the battery monitoring control module -3-.
-- Loosen the nut -1- several turns and remove the battery monitoring control module -3- from the battery negative terminal.
-- Disconnect the connector -2- from the Battery Monitoring Control Module -J367-.
-- Wait 1 minute.
-- Check the voltage of the 12V vehicle electrical system using a commercially available voltmeter.
Conditions
- The voltage must be 0V.
Vehicles with a voltage greater than 0V
-- Refer to DE-ENERGIZED HIGH-VOLTAGE SYSTEM .
-- Check the voltage of the 12V vehicle electrical system using a commercially available voltmeter.
Conditions
- The voltage must be 0V.
Continuation for all vehicles
Connecting
Risk of damaging the positive and negative battery terminal clamps and of the battery terminals.
- The battery terminal clamps for the positive terminal and negative terminal must only be attached by hand and without force.
- Do not put any grease on the battery terminals.
- The battery terminal clamps for the positive terminal and negative terminal must be installed in a way that the battery terminal is flush with the battery terminal clamp or stands out.
-- Attach the battery monitoring control module -3- onto the battery negative terminal.
-- Tighten the nut -1-.
-- Connect the connector -2- from the Battery Monitoring Control Module -J367-.
-- Switch the ignition on.
-- Open and close the door windows all the way.
-- Then, with the windows closed, pull the door window regulator switch until the relay audibly switches.
-- Check the convenience closing from the window regulator motors.
Conditions
- When the "convenience function" is activated, the door windows must close without holding the window regulator button.
The following procedures are necessary so that the ESP indicator lamp turns off:
-- Establish drive ready mode.
-- Engage the position.
-- Turn the steering wheel all the way to the left and to the right.
-- Check and clear the DTC memory using the Vehicle Diagnostic Tool.
Conditions
- The ESP indicator light must go out.
Tightening Specifications
- Refer to Overview - Battery .