Engine Mount, Removing And Installing: Installing

WARNING: This page is about a different car, the 2016 Volkswagen Jetta and 2015 Volkswagen Jetta. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal and note the following:

For all repair work, especially in the engine compartment due to the tight working conditions, observe the following:

Route all wires and lines so that the original path is followed.
Make sure that there is sufficient clearance to all moving or hot components.

-- Install all the engine mount bolts completely by hand.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Tighten the bolts -2 and 3-. The bolt -3- is accessible through the right wheel housing.

-- Align the engine mount -1- so that the distance -a- is the same and is minimum 10 mm.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Tighten the bolts -4-.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Install the bracket and tighten the bolts -5-.

NOTE:

The bolts are only tightened to the final tightening specification after the subframe mounts have been adjusted. Refer to SUBFRAME MOUNT, ADJUSTING .

-- Check the adjustment of the subframe mount. Refer to SUBFRAME MOUNT, CHECKING ADJUSTMENT .