Front Parking Aid Sensors G252/G253/G254/G255, Removing And Installing: Removing

WARNING: This page is about a different car, the 2023 Volkswagen ID.4. However, it is still accessible from the selected car via links, so may be relevant.

Exterior Sensors:

-- Loosen the front wheel housing liner. Refer to FRONT WHEEL HOUSING LINER, REMOVING AND INSTALLING .

-- Press the hook in the -direction of the arrow- and at the same time press the sensor -1- from the outside to the inside.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Disconnect the connector -2- and remove it straight off the parallel sensor -1-.

-- Remove the sensor -1-.

Interior Sensors:

-- Remove the front bumper cover. Refer to BUMPER COVER, REMOVING AND INSTALLING .

-- Press the hook in the -direction of the arrow- and at the same time press the sensor -1- from the outside to the inside.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Disconnect the connector -2- and remove it straight off the parallel sensor -1-.

-- Remove the sensor -1-.

Continuation for all vehicles