Remove & Install or Remove & Replace
WARNING: This page is about the ID.4 1st Edition, which is a different variant/trim than selected.
NOTE: For Independent Suspension Type Axles, Axle Shaft Assembly consists of Axle Shaft, Boots and Joints.
DOES NOT include wheel alignment (unless noted otherwise).| Applies To | Note | Standard Hours | Warranty Hours | Skill Level |
|---|---|---|---|---|
| Both | 2.0 | B | ||
| One Side | 1.3 | B | ||
| Combination Procedure: AXLE SHAFT: Replace: NOTE: For Independent Suspension Type Axles, this operation consists of dissassembly and reassembly of the Axle Shaft Assembly and replacement of the Axle Shaft. | ||||
| One Side | 1.0 | B | ||
| Combination Procedure: AXLE SHAFT BOOT: Remove & Replace: | ||||
| One Side,Inner &/or Outer | 1.0 | B | ||
| Combination Procedure: CONSTANT VELOCITY JOINT: Remove & Replace: | ||||
| Each | 0.5 | B | ||
| Combination Procedure: DIFFERENTIAL OUTPUT SEAL: Remove & Replace: | ||||
| Each Side | 0.2 | B | ||