Adjusting Angle
WARNING: This page is about a different car, the 2020 Volkswagen Arteon and 2019 Volkswagen Arteon. However, it is still accessible from the selected car via links, so may be relevant.
Special tools and workshop equipment required
- Gauge - Frameless Window: T10391
Adjustment Dimensions
- The door window must enter 10 mm -dimension a- into the seal -8- of the window molding.
- In the seal -7- on the rear side window -6-, the door window -1- must rest on the outside -arrow b-.
- The offset with to the B-pillar trim -9- is 1 mm -dimension b-.
-- Remove the rear door trim panel. Refer to REAR DOOR TRIM PANEL, REMOVING AND INSTALLING .
-- Loosen both upper nuts -4-. Set the dimensions using both upper adjusting screws in the nuts -4-.
-- Tighten both upper bolts -4-.
The door window must extend in the center -a arrows- between inner -3- and outer window recess cover -2-.
-- Loosen the lower nut -4-. Set the dimensions using the lower adjusting screw in the nut -4-.
-- Tighten the lower bolt -4-.
Tightening Specifications