BRACKET FOR Vehicle Electrical System Control Module -J519-, REMOVING AND INSTALLING: Removing

WARNING: This page is about a different car, the 2023 Volkswagen Atlas Cross Sport, 2022 Volkswagen Atlas Cross Sport, 2021 Volkswagen Atlas Cross Sport, and 2020 Volkswagen Atlas Cross Sport. However, it is still accessible from the selected car via links, so may be relevant.

-- Disconnect the ground cable from the battery when the ignition is switched off. Refer to BATTERY, DISCONNECTING AND CONNECTING .

-- Remove the instrument panel. Refer to INSTRUMENT PANEL, REMOVING AND INSTALLING .

-- Cut the cable tie -arrow-.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Disengage fuse panel C and push it aside. Refer to RELAY AND FUSE PANEL BEHIND INSTRUMENT PANEL ON DRIVER SIDE, REMOVING AND INSTALLING .

-- Disconnect the connector from the Front Parking Aid Warning Buzzer -H22-.

-- Disconnect the Vehicle Electrical System Control Module -J519- connector. Refer to Vehicle Electrical System Control Module -J519-, REMOVING AND INSTALLING .

-- Remove the bracket for the Parking Aid Control Module -J446- /Parallel Parking Assistance Control Module -J791-. Removing and installing. Refer to PARKING AID / PARALLEL PARKING ASSISTANCE CONTROL MODULE, REMOVING AND INSTALLING .

-- Remove the diagnostic connector by releasing the locking mechanism on the bracket and removing the bracket outward.

-- Remove the bolts -2, 3 and 6-.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Push the bracket -1- far enough forward from the instrument panel crossmember until the alignment pins -4 and 5- are disengaged.

-- Cut the cable ties -arrows-.

-- Free up the wiring harness on the mount.

-- Remove the bracket to the vehicle interior.