Clean Working Conditions

Even a Little Contamination Can Lead to Faults. Observe the following Guidelines for Cleanliness When Working on the Fuel System, Injection System and Turbocharging System:

• Before loosening, connections and surrounding areas must be cleaned thoroughly with engine or brake cleaner, and then cleaned area must be dried completely.
• Seal off any open lines and connections immediately with plugs, for example, take from Engine Bung Set:VAS6122  .
• Place removed parts on a clean surface and cover them. Use a lint-free cloth.
• Carefully cover or seal opened components if repairs are not performed immediately.
• Install only clean parts: Remove the replacement parts from their packaging just before Installing  them. Do not use parts that have been stored out of their original packaging (for example, in tool boxes etc.).
• When the system is open: Do not work with compressed air. Do not move vehicle unless absolutely necessary.
• Protect the disconnected connectors from dirt and moisture and only connect when they are dry.
• In addition, do not let diesel fuel flow onto coolant hoses. If necessary, the hoses must be cleaned again immediately. Replace corroded hoses.