Engine, Installing

WARNING: This page is about a different car, the 2014 Volkswagen Touareg, 2013 Volkswagen Touareg, 2012 Volkswagen Touareg, and 2011 Volkswagen Touareg. However, it is still accessible from the selected car via links, so may be relevant.

-- Raise the drivetrain up until it comes into contact with the body using the : VAS6131 . Be careful of the installed :T10300 when doing this.

-- Attach the subframe to the vehicle. Refer to SUBFRAME .

-- Reconnect all lines, hoses and electrical connections that were disconnected for the removal procedure.

-- Install the plenum chamber cover. Refer to PLENUM CHAMBER COVER .

-- Install the right and left wiper arms. Refer to WINDSHIELD WIPER, REMOVING AND INSTALLING .

-- Fill the power steering fluid. Refer to appropriate service information. .

-- Fill the coolant. Refer to COOLANT, FILLING .

-- If necessary, fill engine oil.

-- Connect the battery. Refer to BATTERY .

-- Adjust the selector lever cable. Refer to SELECTOR MECHANISM, CHECKING [For transmission(s) 0C8] .

-- Fill the ATF. Refer to ATF LEVEL, CHECKING [For transmission(s) 0C8] .

-- Connect the Vehicle Diagnostic Tester.

-- Perform a vehicle system test. Refer to Vehicle Diagnostic Tester.

-- End the vehicle system test in such a way that possibly existing Diagnostic Trouble Code (DTC) entries are automatically erased.

-- Create the readiness code with a road test.

Always observe all safety precautions when performing the road test.

-- Perform another vehicle system test and correct any faults.

NOTE:

If, during the road test, it is discovered that the steering wheel is not exactly straight when driving in a straight line, then perform an axle alignment. Refer to WHEEL ALIGNMENT .