Calibration is necessary if:
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2018 Audi S6, 2018 Audi A6 Quattro, 2018 Audi A6, 2017 Audi S6, and 2017 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
- The fault "no or incorrect basic setting/adaptation" is present in the DTC memory.
- The Night Vision System Camera - R212- is removed or exchanged,
- The bumper or radiator grille is removed or exchanged,
- Adjustment work was performed on the rear axle
- Chassis modifications were performed on the vehicle.
After changes that effect the Night Vision System Control Module - J853- (replacing, software update) a new calibration is not required.
NOTE:
Before calibrating the night vision system, read the DTC memory and perform troubleshooting if necessary. The calibration may only be performed with a VW/Audi approved alignment tester.
Only use the -VAS6430- and -VAS6430/1A- with the associated -VAS6430/6- for calibrating the night vision system.
Only use the -VAS6430- and -VAS6430/1A- with the associated -VAS6430/6- for calibrating the night vision system.