Assembly Mount, Checking Adjustment

WARNING: This page is about a different variant/trim than selected.

There must be a distance -a- of 10 to 13 mm between the engine support and right longitudinal member.

Fig 1: Identifying Subframe Mount
Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.
The casting edge on the engine support -a- must stand parallel to the support arm.
Dimension -b- = dimension -b-.

NOTE:

Distance -a- can also be checked using a suitable round stock.

Only if there is noise (the engine or transmission hitting the longitudinal member when driving around curves) and dimension -a- is not within 10 to 13 mm:

-- Adjust the assembly mount. Refer to ASSEMBLY MOUNT, ADJUSTING .