11.3 Front Peripheral Camera - R243-, Removing And Installing
Special Tools And Workshop Equipment Required
- Torque Screwdriver - VAG1624-
Removing
- Turn off the ignition and all electrical equipment.
- Move the ignition key outside of the vehicle to prevent switching on the ignition unintentionally.
- Remove the front bumper cover. Refer to Body Exterior (Front Bumper; Bumper Cover, Removing and Installing).
- Release and disconnect the connector -7-.
- Remove the bolts -5-.
- Release the retaining tab -6- from the cover -1-.
- Remove the cover -1- toward the front.
- Release the retaining tabs -2- on the bracket -4-.
- Remove the Front Peripheral Camera - R243- -3- forward out of the bracket -4-.
- Remove the bolts -8-.
- Unclip the bracket -4- from the front bumper cover.
Installing
Install in reverse order of removal and note the following:
- Calibrate the peripheral camera. Refer to 11.7 Peripheral Camera, Calibrating
TIGHTENING SPECIFICATIONS
| Component | Tightening Specification |
|---|---|
| Bracket to front bumper cover | 1 Nm |
| Bracket to cover | 1 Nm |