Adaptive Cruise Control (ACC), Calibrating
Conditions
- The Control Module for Adaptive Cruise Control - J428- must be calibrated under the following conditions:
- Control Module for Adaptive Cruise Control - J428- was replaced.
- Lock carrier service position was performed
- Lock carrier was removed and installed
- Lock carrier was replaced
- Rear axle toe was adjusted
NOTE:
- Too great of a horizontal adjustment of the Control Module for Adaptive Cruise Control - J428- causes the ACC/Front Assist functions to remain switched off. This is indicated by the following message in the Instrument Cluster - KX2-: ACC/Front Assist not available.
- A limited sensor view due to a dirty sensor or inclement weather conditions (for example, heavy rain, snowfall, iced over sensor etc.) causes the ACC/Front Assist functions to be temporarily unavailable. This is indicated by the following message in the Instrument Cluster - KX2-: ACC/Front Assist: No sensor view.
- Calibrate the adaptive cruise control. Refer to Adaptive Cruise Control, Calibrating.