Rearview Camera -R189-, Removing And Installing: Installing
WARNING: This page is about a different car, the 2017 Volkswagen Golf SportWagen, 2017 Volkswagen Golf Alltrack, 2016 Volkswagen Golf SportWagen, and 2015 Volkswagen Golf SportWagen. However, it is still accessible from the selected car via links, so may be relevant.
Install In Reverse Order Of Removal. Note The Following:
CAUTION:
- Risk of leaks
- Water could enter the luggage compartment if the seals are twisted or are not positioned correctly.
- Make sure the installed seal is in good condition and installed correctly.
-- Check the rubber seal -1- surrounding the pivoting emblem and ensure that it is completely in the groove.
-- Connect the water drain hose to the hose grommet on the bottom of the pivoting emblem.
-- Rotated to the right, insert the pivoting emblem into the rear lid.
-- Engage the pivoting emblem in the rear lid by turning it to the left.
-- Install the pivoting emblem bolts -arrows- without tightening them.
-- Center the pivoting emblem with the body opening in the rear lid.
-- Tighten the three screws -arrows-.
-- Secure the wires and connectors with the retainers again to prevent rattling noises.
-- After installing, clean the rearview camera lens with lint-free cloth.