Windshield Wiper Arms, Removing And Installing: Removing

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2015 Audi S8, 2015 Audi A8 Quattro, 2014 Audi S8, 2014 Audi A8 Quattro, and 2013 Audi S8. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

If the windshield wiper motor is to be run during the work procedure, the hood must be closed. Otherwise, the voltage supply of the wiper motor will be interrupted.

-- Bring the windshield wiper into service position, refer to WIPER WIPER, MOVING INTO SERVICE POSITION .

-- Pry the caps -arrows- off of the windshield wiper arms -1- with a screwdriver.

Fig 1: Identifying Windshield Wiper Arm Nut

Courtesy of AUDI OF AMERICA, LLC

-- Loosen the nuts -2- a few turns.

-- Position the Puller - Wiper Arm Kit - Puller 1 T10369/1 on the wiper arm -1- as illustrated.

-- Position the thrust piece -2- on the wiper axle.

Fig 2: Identifying Windshield Wiper Arm And Puller T10369/1

Courtesy of AUDI OF AMERICA, LLC

-- Rotate the bolt -3- clockwise until the wiper arm is removed from the axle.

-- Remove the nuts and remove the wiper arm.