Steering Column Electronics Systems Control Module J527 , removing and installing
WARNING: This page does not describe the selected car, but rather 16 other vehicles, including the 2009 Audi S4, 2009 Audi A4, 2008 Audi S4, 2008 Audi RS 4, and 2008 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.
Removing
NOTE:
- Should the Steering Column Electronic Systems Control Module J527 require replacement, follow applicable component "Replacement" procedure using VAS 5051/5051 in operating mode "Guided Fault Finding".
- Remove steering column switch module → Steering column switch module, removing and installing .
CAUTION:
- Ensure steering is in straight ahead and centered prior to removing spiral spring.
- Position of spiral spring must not be changed once removed.
- Carefully release clip fasteners - arrows - and remove spiral spring - 1 - from steering column switch module.
Fig 2: Removing Steering Angle Sensor G85 From Steering Column Electronic Systems Control Module J527
- Remove Steering Angle Sensor G85 - 1 - from Steering Column Electronic Systems Control Module J527 in direction of - arrow -.
Fig 3: Removing Screws, And Steering Column Electronics Systems Control Module J527 From Steering Column Switch Module
- Remove screws - arrows -.
- Remove Steering Column Electronics Systems Control Module J527 - 1 - from steering column switch module.
Installing
Install in reverse order of removal, noting the following:
- Ensure all fasteners and electrical connectors are properly connected and locked into place.
- Install steering column switch module Installing .
Tightening torques
| Component | Nm |
| Steering column switch module to Steering Column Electronics Systems Control Module J527 | 0.6 |
| Intermittent wiper switch E22 to Steering Column Electronics Systems Control Module J527 | 0.6 |
| Cruise Control Switch E45 to Steering Column Electronic Systems Control Module J527 | 0.6 |