Windshield, Removing And Installing: Removing

-- Remove the left and right A-pillar upper trim panels. Refer to Vehicle Interior Trim Panels .

-- Remove the left and right sun visors. Refer to the appropriate service information .

-- Remove the interior rearview mirror. Refer to Interior Rearview Mirror, Removing and Installing .

-- For vehicles with a Driver Assistance Systems Front Camera -R242-, remove the front camera. Refer to Driver Assistance Systems Front Camera, Removing and Installing .

-- Lower the headliner near the windshield. Refer to Roof Trim Panels .

-- The headliner can now be lowered far enough so that the windshield can be cut out without damaging the headliner.

-- Remove the plenum chamber cover. Refer to PLENUM CHAMBER COVER, REMOVING AND INSTALLING .

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

For Vehicles with Windshield Defogger

-- Remove the hex nut -6- and attach the wire -5- to the windshield.

-- Disconnect the connectors -1 and 3-.

-- Attach the wires -2 and 4- to the windshield.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Slide the :VAG1474/8  between the windshield and the instrument panel.

-- Pull the cutting wire end -1- through the adhesive inside the vehicle interior using the :VAG1474/2  .

-- Secure the cutting wire end from being pulled out using the :VAG1351/1  -3-.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Insert the cutting wire -2- into the window glass flange using the small tube -1-.

-- Lay the cutting wire around the windshield.

-- Make sure that the cutting wire is inserted under windshield at the corners.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Secure the wire ends -4- on the :VAS6452  -1-.

-- Place the cutting wire around the reel device suction cups -arrow-.

-- While cutting free, press the cutting wire against the windshield using a plastic wedge -2- in order to have clearance on the window glass flange and the instrument panel.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Position the :VAS6452  in the lower corners of the windshield.

-- Move the left :VAS6452  from "position I" through "position III" in sequence and cut the windshield free.

-- Move the right :VAS6452  from "position IV" through "position VI" in sequence and cut the windshield free.

-- Using two :VAG1344  , lift the windshield from the vehicle.