Operation 1: Checking DTC memory
WARNING: This page is about a different car, the 2006 Audi A4, 2005 Audi A4, 2004 Audi A4, 2003 Audi A4, and 2002 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.
Test conditions
- Engine stopped, ignition switched on
- Connect vehicle diagnostic, testing and information system VAS5051. Refer to Vehicle diagnostic, testing and information system VAS5051, connecting and select functions and select vehicle system "01 -Engine electronics" in selection. Ignition must be switched on.
Display on VAS5051:
- Under -1- select diagnostic function "02 - Check DTC memory".
Fig 2: Identifying Content Of DTC Memory & Identification Of Fault On Diagnostic System VAS 5051 Display
Display on VAS5051:
1 - Contents of fault memory:
0 Faults recognized
or
X Faults recognized
2 - Fault
Fault code
Fault location
Fault type
If a fault is stored:
- Repair malfunction and erase DTC memory. Perform a road test and check DTC memory again.
If no DTC is stored:
- Press ← button.
- Perform next operation.