LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Volkswagen >> 2017 >> e-Golf SE >> Repair and Diagnosis >> External Pages >> Different car >> Section 101 (Automatic Transmission - Diagnostics) >> Subaru Select Monitor >> Operation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Subaru Select Monitor: Operation

WARNING: This page is about a different car, the 2012 Subaru Forester. However, it is still accessible from the selected car via links, so may be relevant.
  1. Prepare the Subaru Select Monitor kit.
    Fig 1: Subaru Select Monitor Kit
    G07665835Courtesy of SUBARU OF AMERICA, INC.
  2. Prepare PC with Subaru Select Monitor installed.
  3. Connect the USB cable to SDI (Subaru Diagnosis Interface) and USB port on the personal computer (dedicated port for the Subaru Select Monitor).
    NOTE: The dedicated port for the Subaru Select Monitor means the USB port which was used to install the Subaru Select Monitor.
  4. Connect the diagnosis cable to SDI.
  5. Connect SDI to data link connector located in the lower portion of the instrument panel (on the driver's side).
    Fig 2: Locating Data Link Connector In Lower Portion Of Instrument Panel (On Driver's Side)
    G07665836Courtesy of SUBARU OF AMERICA, INC.
    CAUTION: Do not connect scan tools other than the Subaru Select Monitor.
  6. Start the PC.
  7. Turn the ignition switch to ON.
  8. Run the "PC application for Subaru Select Monitor".
scientia non olet · About LEMON Manuals