Manifold Absolute Pressure (MAP) / Intake Air Temperature 2 (IAT2) Sensor: Installation
WARNING: This page is about a different car, the 2017 Lincoln Navigator and 2017 Ford Expedition. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Lubricate the O-ring seal with clean engine oil.
- 1.
- Install the MAPT sensor and bolt, tighten to 3 Nm (27 lb-in).
- Connect the MAPT electrical connector.
 Courtesy of FORD MOTOR COMPANY
|
- 2.
Remove the oil filler cap and install the engine appearance cover. Install the oil filler cap.
 Courtesy of FORD MOTOR COMPANY
|