Cylinder Head Temperature (CHT) Sensor: Removal

WARNING: This page is about a different car, the 2017 Lincoln Navigator and 2017 Ford Expedition. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Removal steps in this procedure may contain installation details.

1.

Remove the RH fender splash shield. Refer to Front End Body Panels .

2.

Disconnect the Cylinder Head Temperature (CHT) sensor electrical connector.

Courtesy of FORD MOTOR COMPANY

3.

Remove the CHT sensor.
- To install, tighten to 10 Nm (89 lb-in).

Courtesy of FORD MOTOR COMPANY