Overview - Assembly Mounts, Vehicles With 8- Or 12-Cylinder Engine
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2018 Audi S8, 2018 Audi A8 Quattro, 2017 Audi S8, 2017 Audi A8 Quattro, and 2016 Audi S8. However, it is still accessible from the selected car via links, so may be relevant.
- Right Transmission Mount
- With Transmission Mount Valve 1 -N262-
- Removing and installing. Refer to TRANSMISSION MOUNT, REMOVING AND INSTALLING .
- Bolt
- 20 Nm
- Brace
- Bolt
- 20 Nm
- Right Transmission Support
- Removing and installing. Refer to TRANSMISSION MOUNT, REMOVING AND INSTALLING .
- Bolt
- 20 Nm
- Bolt
- 40 Nm
- Heat Shield
- Bolt
- 10 Nm
- Not Installed
- Not Installed
- Tunnel Crossmember
- Removing and installing. Refer to TUNNEL CROSSMEMBER, REMOVING AND INSTALLING, VEHICLES WITH 8 OR 12-CYLINDER ENGINE
- Rear Transmission Support
- Removing and installing. Refer to TRANSMISSION MOUNT, REMOVING AND INSTALLING
- Nut
- 20 Nm
- Only remove if the transmission mount must be separated from the transmission support
- Bolt
- 40 Nm
- Rear Transmission Mount
- Removing and installing. Refer to TRANSMISSION MOUNT, REMOVING AND INSTALLING .
- Lower Stop
- For the rear transmission mount
- Bolts
- 20 Nm + an additional 90° turn
- Always replace
- Only remove if the transmission mount must be separated from the transmission support
- Bolt
- M10 x 55 8.8: 40 Nm
- M10 x 40 10.9: 70 Nm
- Bolt
- 40 Nm
- Left Transmission Support
- Heat Shield
- Bolt
- 10 Nm
- Bolt
- 20 Nm
- Brace
- Bolt
- 20 Nm
- Left Transmission Mount
- With Transmission Mount Valve 2 -N263-
- Removing and installing. Refer to TRANSMISSION MOUNT, REMOVING AND INSTALLING
- Bolt
- 20 Nm
- Nut
- 20 Nm