Intake manifold upper-part, component overview: Notes
WARNING: This page is about a different car, the 2009 Audi A4, 2008 Audi A4, 2007 Audi A4, 2006 Audi A4, and 2005 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.
1 - Intake Manifold Tuning (IMT) Valve Position Sensor G513
2 - 2.5 Nm
3 - 2.5 Nm
4 - Actuator for intake manifold change-over
- Installed location of tooth segments for variable intake manifold Installed location of tooth segments for variable intake manifold
- As replacement part together with - 24 -
5 - Seal
- Replace if damaged
- Lift out with screwdriver to replace
- Press in by hand
6 - Ball pin, 2.5 Nm
7 - Intake manifold upper part
- Removing and installing → Intake manifold upper-part, removing and installing
8 - Throttle valve control module J338
9 - 5 Nm
10 - Wire harness retainer
11 - Seal
- Replace
12 - Intake Manifold Runner Control (IMRC) Valve N316
13 - 2.5 Nm
14 - Intake Air Temperature (IAT) Sensor G42/Manifold Absolute Pressure (MAP) Sensor G71
15 - O-ring
- Replace
16 - 2.5 Nm
17 - Crankcase housing ventilation pressure regulator valve
18 - O-ring
- Replace
19 - 6 Nm
20 - Washer
21 - Sleeve
22 - Seals
- Replace
23 - Seal
- Replace if damaged
- Lift out with screwdriver to replace
- Press in by hand
24 - Lever with tooth segment
- For variable intake manifold
- Installed location of tooth segments Installed location of tooth segments for variable intake manifold
- As replacement part together with - 4 -
25 - Seal
- Replace if damaged
- Lift out with screwdriver to replace
- Press in by hand
26 - Change-over valve for intake manifold flap N239