Headlamp Adjustment, Checking (ECE)

NOT FOR NORTH AMERICAN MARKET

Special Tools And Workshop Equipment Required

Headlamp Adjusting Unit :VAS5046A
Headlamp Adjusting Unit :VAS5047A
Headlamp Adjusting Unit :VAS621 001

NOTE:

For certain markets, no manual headlamp range control is offered with halogen headlamps.

-- Check the headlamp height adjustment by setting to the maximum level and observing the light.

-- Then set the thumbwheel for the headlamp range control to the 0 position, if equipped.

The adjustment of the angle dimension on headlamp adjusting unit is based on the fuel tank fill level.

Angle Dimension For Halogen Headlamp ECE

Fuel Gauge Level	Angle Dimension
0 to 1/2	1.2 %
1/2 to 1	1.0 %

Check the following:

-- With the low beam switched on, check whether the horizontal cut-off line contacts the test surface dividing line -1- and

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- If the bend point -2- runs vertically through the central point -3- between the left horizontal part and the rising part on the right of the cut-off line. The bright core of the light beam must be on the right of the vertical line.

NOTE:

After adjusting the low beam according to the instructions, the center of the high beam light beam must lie on the center mark -3-.