Engine, Removing: Notes
WARNING: This page is about a different car, the 2015 Volkswagen Golf SportWagen. However, it is still accessible from the selected car via links, so may be relevant.
Special tools and workshop equipment required
- Engine and Gearbox Jack:VAS6931
- Engine Bung Set:VAS6122
- Shop Crane - Drip Tray:VAS6208
- Hose Clip Pliers:VAS6362
- Locking Pin:T10060A
- Engine Support:T10497 with Engine Support - Pins:T10497/1
- Engine Support - Clamp:T10497/4
- Pry Lever:80-200
- Protective Mat:VAS531003
- Commercially Available Step Ladder
- Protective Eyewear
- Safety Gloves
CAUTION:
This procedure contains mandatory replaceable parts. Refer to component overview prior to starting procedure.
Mandatory Replacement Parts
- Bolts - Engine Mount
- Bolts - Transmission Mount
CAUTION:
After the high pressure line assembly, and when installing a new short engine, it is particularly important to tighten the fuel injector tensioning clamps to the previously mentioned tightening specification. Refer to OVERVIEW - FUEL INJECTORS . Only tighten the tensioning claws >>hand tight<< after delivery when assembling the high pressure lines in order to align the fuel injectors. Engine damage may occur if not observed.