Rearview Camera -R189-, Removing And Installing: Installing
Install In Reverse Order Of Removal. Note The Following:
CAUTION:
- Risk of leaks
- Water could enter the luggage compartment if the seals are twisted or are not positioned correctly.
- Make sure the installed seal is in good condition and installed correctly.
-- Check the rubber seal -1- surrounding the pivoting emblem and ensure that it is completely in the groove.
-- Connect the water drain hose to the hose grommet on the bottom of the pivoting emblem.
-- Rotated to the right, insert the pivoting emblem into the rear lid.
-- Engage the pivoting emblem in the rear lid by turning it to the left.
-- Install the pivoting emblem bolts -arrows- without tightening them.
-- Center the pivoting emblem with the body opening in the rear lid.
-- Tighten the three screws -arrows-.
-- Secure the wires and connectors with the retainers again to prevent rattling noises.
-- After installing, clean the rearview camera lens with lint-free cloth.