Upper Intake Manifold Overview
WARNING: This page is about a different car, the 2012 Audi Q5, 2011 Audi Q5, 2010 Audi Q5, and 2009 Audi Q5. However, it is still accessible from the selected car via links, so may be relevant.
- Vacuum Hose
- Intake Manifold Tuning (IMT) Valve -N156-
- Bolt
- 2.5 Nm
- For Intake Manifold Tuning (IMT) Valve Position Sensor -G513-
- Bolt
- 2.5 Nm
- Actuator for Intake Manifold Change-Over
- Installed location of tooth segments for variable intake manifold, refer to Fig 2
- As replacement part together with -26-
- Seal
- Replace if damaged
- Lift out with screwdriver to replace
- Press in by hand
- Ball Pin
- 2.5 Nm
- Upper Intake Manifold
- Removing and installing, refer to UPPER INTAKE MANIFOLD
- Seal
- Replace
- Throttle Valve Control Module -J338-
- Bracket
- Bolt
- 6 Nm
- Evaporative Emission (EVAP) Canister Purge Regulator Valve -N80-
- Hose
- Bolt
- 3 Nm
- Intake Air Temperature (IAT) Sensor -G42- /Manifold Absolute Pressure (MAP) Sensor -G71-
- O-ring
- Replace
- Bolt
- 2.5 Nm
- Hose for Crankcase Ventilation
- O-ring
- Replace
- Bolt
- 8 Nm
- Washer
- Sleeve
- Seals
- Replace
- Seal
- Replace if damaged
- Lift out with screwdriver to replace
- Press in by hand
- Lever with Tooth Segment
- For variable intake manifold
- Installed location of tooth segments, refer to Fig 2
- As replacement part together with -5-
- Seal
- Replace if damaged
- Lift out with screwdriver to replace
- Press in by hand
- Vacuum Hose
- The lower edges of the toothed segments must align with one another -arrow-.