LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Volkswagen >> 2016 >> Golf Base, Eng CD CXBA, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 6 (Engine Assembly (Service Information - CRUA)) >> 10 Engine Assembly >> Assembly Mounts >> Transmission Mount, Removing And Installing >> Installing
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Transmission Mount, Removing And Installing: Installing

WARNING: This page is about a different car, the 2015 Volkswagen Golf. However, it is still accessible from the selected car via links, so may be relevant.

Install In Reverse Order Of Removal And Note The Following: 

NOTE:

Replace the bolts that were tightened with an additional turn after removing them.

-- Secure the transmission support to the longitudinal member.

CAUTION:

Risk of damaging threads in transmission support by inserting bolts at an angle.

  • The transmission support and the transmission support arm must be absolutely parallel to each other before installing the bolts. Push the rear of the transmission upward using a floor jack if necessary.
  • Only remove the :10-222A  when bolts for the assembly mounts are tightened to tightening specification.

-- Lift the transmission using the engine support bridge spindle until the transmission support touches the support arm.

-- Check the adjustment of the assembly mounts. Refer to ASSEMBLY MOUNTS, CHECKING ADJUSTMENT .

-- Remove the :10-222A  from the engine.

scientia non olet · About LEMON Manuals