Backrest Release Cable, Adjusting

WARNING:

Make sure the backrest is locked (zero position), otherwise it could tip forward accidentally.

-- Remove the backrest cover with the backrest cushion. Refer to BACKREST COVER AND CUSHION, REMOVING AND INSTALLING .

The Following Prerequisites Must Be Met To Adjust:

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

Backrest release -2- to the lower stop (backrest locks).

-- Pivot the backrest release bearing -1- upward until a distance of -a- = 2 to 4 mm is between the backrest frame stop surface -arrow A- and the bearing stop -arrow B-.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Secure the backrest release bearing in this position, using for example an angled metal rod.

-- Adjust the release cables on both release cable adjusters -1 and 2-.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- To adjust, turn the upper section -3- and the lower section -4- contrary to each other.

-- Adjust the cable so it is free of play and tension.

NOTE:

The illustration only shows one side of the retainer.

When adjusting cables -1-, they must not be tensioned at the backrest release -2-.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- After adjusting release cables, perform a functionality test of the backrest release.

-- If it does not release or only releases partially, check the release cable routing or repeat the adjustment.