Adjustment Overview
WARNING: This page is about a different variant/trim than selected.
NOTE:
A re-adjustment of the drive axle, output shaft or differential is only required only required if components, which have a direct influence on transmission adjustment, have been replaced. Note the following table to avoid unnecessary adjustments:
DRIVE AXLE, INPUT/OUTPUT SHAFT OR DIFFERENTIAL SPECIFICATION
| Input Shaft. Refer to INPUT SHAFT, ADJUSTING | to be adjusted: Output Shaft. Refer to OUTPUT SHAFT, ADJUSTING . | Differential Refer to "DIFFERENTIAL, ADJUSTING " . | ||
|---|---|---|---|---|
| Replaced part: | Transmission Housing | x | x | |
| Clutch Housing | x | x | x | |
| Input Shaft | x | |||
| Output Shaft | x | |||
| Differential | x | |||
| Output shaft tapered roller bearing | x | |||
| Output shaft tapered roller bearing | x | |||
| Differential tapered roller bearing | x | |||
| 4th Gear Wheel | x | |||