Rear Wheel Speed Sensor, AWD

WARNING: This page is about a different car, the 2014 Volkswagen Jetta, 2013 Volkswagen Jetta, 2012 Volkswagen Jetta, 2011 Volkswagen Jetta, and 2010 Volkswagen Jetta. However, it is still accessible from the selected car via links, so may be relevant.

Removing

-- Raise vehicle.

-- Separate speed sensor and speed sensor wiring connector -1-.

Fig 1: Identifying Speed Sensor Wiring Connector And Bolt On Rear Axle

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Remove bolt -2- from wheel bearing housing.

-- Remove ABS speed sensor from wheel bearing housing.

Installing

-- Before inserting speed sensor, clean hole inner surface and coat speed sensor all-round with hot bolt paste G 052 112 A3.

-- Insert the speed sensor into the hole in the wheel bearing housing and tighten the bolt to 8 Nm.

-- Connect speed sensor to speed sensor wiring.