Fastener Tightening Specifications: Notes
WARNING: This page is about a different car, the 2014 Volkswagen Jetta, 2013 Volkswagen Jetta, 2012 Volkswagen Jetta, 2011 Volkswagen Jetta, and 2010 Volkswagen Jetta. However, it is still accessible from the selected car via links, so may be relevant.
| Component | Fastener Size | Nm | ||
|---|---|---|---|---|
| Wire Bracket to Mechatronic (Large) Cover Nut | - | 10 | ||
| Fluid Drain Plug | - | 45 | ||
| Mechatronic (Large) Cover Bolt (1) | - | 10 | ||
| Oil Filter Housing | - | 20 | ||
| Oil Pump (Small) Cover Bolt (1) | - | 8 | ||
| Overflow Tube | - | 3 | ||
| Selector Shaft Lever Nut | - | 20 | ||
| Transmission Fluid Cooler to Transmission Bolt | - | 20 + 90° | ||
| Transmission Input Speed and Clutch Oil Temperature Sensor Bolt | - | 10 | ||
| Selector Mechanism, through 02.09 | ||||
| Bolt (with Spring) to Selector Mechanism | - | 3 | ||
| Selector Housing to Body/Selector Mechanism Nut | - | 9 | ||
| Selector Lever Cable Adjusting Bolt | - | 13 | ||
| Selector Mechanism to Body Nut | - | 8 | ||
| Selector Mechanism, from 03.09 | ||||
| Selector Housing to Body Nut | - | 8 | ||
| Selector Lever Cable Adjusting Bolt | - | 13 | ||
| Selector Mechanism with Selector Lever and Selector Lever Cable to Body Bolt | - | 8 | ||
|
||||
Mechatronic Unit Bolt Tightening Sequence and Specifications
-- Install the new bolts -1 through 10- by hand.
-- Tighten the new bolts -1 through 10- in the specified sequence to 5 Nm. Then tighten them an addition 90° (1/4) turn in the same order.
Oil Pump Bolt Variety and Tightening Specification
All four bolts - arrows- with flat heads
Tightening specification: 5 Nm + 90° (1/4 turn) additional turn
3 bolts with flat head, top bolt -arrow- is countersunk
Tightening Specification:
- Countersunk bolt: 8 Nm (tighten using the special wrench, long reach T10054)
- Flat head bolts: 8 Nm + 90° (1/4) additional turn