Vehicle Electrical System Control Module -J519-, LOW VERSION

WARNING: This page is about a different car, the 2014 Volkswagen Jetta, 2013 Volkswagen Jetta, 2012 Volkswagen Jetta, and 2011 Volkswagen Jetta. However, it is still accessible from the selected car via links, so may be relevant.

If the Vehicle Electrical System Control Module -J519- is to be replaced, the "Replace the vehicle electrical system control module" procedure must always be performed to read out the data stored in the Vehicle Electrical System Control Module -J519-, refer to Vehicle Electrical System Control Module -J519-, REPLACING .

An LHD vehicle is shown in the following figures. The procedure for removing and installing the Vehicle Electrical System Control Module -J519- on a RHD vehicle is identical.

Removing

-- Turn off the ignition and all electrical consumers and remove the ignition key.

-- Remove the instrument panel cover on the driver side, refer to DRIVER SIDE INSTRUMENT PANEL COVER .

-- Loosen the locking mechanisms -3- and push the Vehicle Electrical System Control Module -J519- -2- downward in the direction of the -arrow-.

Fig 1: Removing Vehicle Electrical System Control Module

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Release and disconnect the connectors -1-.

Installing

Install in reverse order of removal.