Vehicle Electrical System Control Module -J519-, HIGH VERSION

WARNING: This page is about a different car, the 2014 Volkswagen Jetta, 2013 Volkswagen Jetta, 2012 Volkswagen Jetta, and 2011 Volkswagen Jetta. However, it is still accessible from the selected car via links, so may be relevant.

If the Vehicle Electrical System Control Module -J519- is to be replaced, the "Replace the vehicle electrical system control module" procedure must always be performed to read out the data stored in the Vehicle Electrical System Control Module -J519-, refer to Vehicle Electrical System Control Module -J519-, REPLACING .

An LHD vehicle is shown in the following figures. The procedure for removing and installing the Vehicle Electrical System Control Module -J519- on RHD vehicles is identical.

It is permissible for the number of connectors to deviate from the graphic below, depending on the vehicle variants.

Removing

-- Turn off the ignition and all electrical consumers and remove the ignition key.

-- Remove the instrument panel cover on the driver side, refer to DRIVER SIDE INSTRUMENT PANEL COVER .

-- Press the catches -arrows- and swivel the Vehicle Electrical System Control Module -J519- downward.

Fig 1: Identifying Vehicle Electrical System Control Module

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Pull the Vehicle Electrical System Control Module -J519- downward and opposite the drive direction and remove it from the bracket.

-- Release and disconnect the connectors.

Installing

Install in reverse order of removal. Note the following:

-- Insert the Vehicle Electrical System Control Module -J519- first with the back of the module into the bracket and push it up until it audibly latches.