Vehicle Electrical System Control Module -J519- DESCRIPTION
General Information
The Vehicle Electrical System Control Module -J519- is clipped to the bottom of the relay panel and can be removed.
In the Low version, the Data Bus On Board Diagnostic Interface -J533- is integrated in the Vehicle Electrical System Control Module -J519-.
The Vehicle Electrical System Control Module -J519- has the following functions in the vehicle:
Low version
- Audible confirmation when locking and unlocking
- Expressway blinking, activating/deactivating
- Adapts automatic unlocking when key removed
- Adapts automatic locking at 15 km/h
- Adapts automatic locking of rear lid at 5 km/h
- Activates and deactivates parking lamp on both sides
- Adapts the blink cycles for convenience turn signals
- Vehicle Electrical System Control Module -J519-, Coding
- Adapts single door opening
- Deactivates factory mode
- Confirms convenience closing with turn signals
- Adapts the market version for the intelligent alarm horn
- Reads the measured value for Vehicle Electrical System Control Module -J519- Convenience
- Reads the measured value for Vehicle Electrical System Control Module -J519- central electric
- Interior light control
- Activates/deactivates emergency braking blinking
- Activates/deactivates emergency blinking
- Optical confirmation when locking and unlocking
- Activates/deactivates parking lamps
- Codes Rain/Light Recognition Sensor -G397-
- Adapts the switch-on time for the exterior mirror heating
- Adapts the switch-on time for the rear window defogger
- Adapts the remote control key
- Checks the remote control key
- Activates/deactivates the windshield wiper service position
- Adapts horn at terminal 15
- Activates/deactivates position lamp at terminal 15
- Vehicle Electrical System Control Module -J519- Output Diagnostic Test Mode
- Activates/deactivates intermediate wiping
High Version
- Electric load management/exterior lighting control
- Turn signal control
- Windshield wiper and washer system
- Codes Rain/Light Recognition Sensor -G397-
- Rear window defogger
- Interior light control
- Terminal control
- Dimming, instrument illumination
- Footwell Lights
- Fuel Pump (FP) supply
- Pre-energizing of generator
- Horn
- Warning lamp
- Release control
- Control central locking
- Front and rear door control module activation
- Rear lid remote unlock activation
- Fuel tank unlock activation
- Anti-Theft Alarm System activation
- Anti-theft immobilizer activation
- Start authorization activation
- Acoustic Acknowledgement when Unlocking, Adapting
- Acoustic acknowledgment when locking, adapting, refer to.
- Blinking Cycle during One-Touch Lane Change Signaling, Adapting
- Adapts automatic unlocking when key removed
- Adapts automatic locking at 15 km/h
- Adapts Convenience locking confirmation
- Adapts coming home time
- Adapts leaving home time
- Adapts anti-theft alarm delay when opening driver door
- Adapts single door opening
- Deactivates factory mode
- Adapts footwell illumination intensity
- Adapts Convenience operation via remote control
- Adapts the market version for the intelligent alarm horn
- Adapts visual acknowledgment for locking
- Adapts the remote control key
- Checks the remote control key
- Vehicle Electrical System Control Module -J519- Output Diagnostic Test Mode
- Deactivates Wiper Motor Control Module -J400- APP function
- Vehicle Electrical System Control Module -J519-, Coding
It depends on the vehicle equipment whether the adaptations listed above can be performed.
If the Vehicle Electrical System Control Module -J519- is to be replaced, the "Replace the vehicle electrical system control module" procedure must always be performed to read out the codes stored in the Vehicle Electrical System Control Module -J519-.
DTC recognition and display
The Vehicle Electrical System Control Module -J519- is equipped with OBD.
For troubleshooting, use the Vehicle Diagnostic Tester in the "Guided Fault Finding" function.