Service Interval Display, Coding At The First Oil Change (For USA And CANADA)

WARNING: This page is about a different car, the 2014 Volkswagen Jetta, 2013 Volkswagen Jetta, 2012 Volkswagen Jetta, and 2011 Volkswagen Jetta. However, it is still accessible from the selected car via links, so may be relevant.

-- Connect the Vehicle Diagnostic Tester. Refer to VEHICLE DIAGNOSTIC TESTER, CONNECTING .

-- Switch on the ignition.

-- Press: "OBD" on the touch screen.

NOTE:

If the displays indicated in the procedure are not shown on the display. Refer to Operating instructions for Vehicle Diagnostic Tester or Vehicle Diagnostic Tester.

-- Select the following one after the other:

Brand
Type
Model year
Engine code

-- Confirm the VIN.

If the vehicle identification procedure was performed correctly, press > button for confirmation.

-- Select the following one after the other:

17 "Instrument Cluster" -ARROW-.

Fig 1: Diagnosis System Display: 17 - Instrument Panel Insert
Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.
10 "Adaptation"

-- Select channel 49.

-- Enter 372.

-- Select channel 42.

-- Perform adaptation according to instructions of "ON BOARD DIAGNOSTICS (OBD)".

NOTE:

The following applies to USA and Canada vehicles:

Channel 42: 100 (= 10, 000 miles) for USA

Channel 42: 160 (= 16.000 km) for CDN

Channel 49: 372 (= 372 days) for USA and CDN

Ending the Adaptation:

Indicated on display:

Fig 2: Identifying "Go To" Button On Scan Tool Display

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Press the Go to button -arrow- on display.

Indicated on display:

Fig 3: Identifying "Exit" Button On Scan Tool Display

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Press the End button -arrow- on the display.

-- Turn off the ignition and disconnect the diagnostic connector.