LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Volkswagen >> 2015 >> Golf SportWagen TDI S, Standard Trans >> Repair and Diagnosis (Single Page) >> Engine Mechanical >> Auxiliary Emission Control Systems >> Exhaust System & Emissions System (Service Information - CRUA) >> 26 Exhaust System, Emission Controls >> Emissions Control System >> Emissions Control Module, Removing And Installing >> Installing >> Notes
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Emissions Control Module, Removing And Installing: Installing: Notes

NOTE:

Pay attention that the :T10511  retaining bracket is pivoted in the bulkhead direction - >>open<<.

Replace the seals, self -locking nuts, and clamps for the emissions control module after removing.

During installation, all cable ties for the heat shields must be installed at the same location.

CAUTION:

There is a risk of stress fractures and engine damage due to the emissions control module being installed under stress.

  • Before installing make sure that this lifter is not difficult to move or fixed.
  • The lifter must be easy to turn on the threads.
  • Lubricant can only be applied on the threads. The retainers must remain >>clean<<.
  • The bolt retaining tabs must be bent together so far that the lifter is taken with when the bolt is turned.
scientia non olet · About LEMON Manuals