Assembly Mounts, Checking Adjustment: Procedure

WARNING: This page is about a different variant/trim than selected.

The Following Dimensions Must Be Attained:

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

The distance -a- between the engine support -2- and the engine mount -1- must be 10 mm.
The casting edge on the engine support must be parallel to the engine mount support arm

NOTE:

Distance -a- = 10 mm can also be checked with corresponding round stock.

-- If the distance measured is too small or too large, adjust the subframe. Refer to ASSEMBLY MOUNTS, ADJUSTING .