Engine Control Module -J623-
If the Engine Control Module -J623- is to be replaced, connect the vehicle diagnostic tester and perform "Guided Functions, Replacing Engine Control Module".
Conditions
- Ignition is turned off.
Removing
-- Remove the E-box cover -arrows- inside the engine compartment.
With Anti-Theft Protection
-- Remove the shear bolts -2-.
-- Remove the locking mechanism bracket -5-.
-- Disconnect the connectors -1 and 3- from the Engine Control Module -J623-.
-- Remove the shear bolts -6- and the lock mechanism bracket -4-.
Without Anti-Theft Protection
-- Disconnect the connectors -1 and 3- from the Engine Control Module -J623-.
Continuation for All
-- Push the tabs on the side guides -3- carefully toward the outside -direction of arrow- with a screwdriver -2-.
-- Remove the Engine Control Module -J623- -1- from the guides -3-.
Installing
-- Install the Engine Control Module -J623- -1- into the guides -3- until it locks.
With Anti-Theft Protection
-- Attach the locking mechanism bracket -4- to the Engine Control Module -J623- with the shear bolts -6-.
-- Install the shear bolts until the bolt heads break off.
-- Connect the connectors -1 and 3- to the Engine Control Module -J623-.
-- Install the locking mechanism bracket -5- with the shear bolts -2-.
-- Install the shear bolts until the bolt heads break off.
Without Anti-Theft Protection
-- Connect the connectors -1 and 3- to the Engine Control Module -J623-.
Continuation for All
-- Install the E-box cover -arrows-.