LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Volkswagen >> 2014 >> CC 4Motion >> Repair and Diagnosis >> General Information >> Reset Procedures >> Tire Pressure Monitor Systems >> TPMS Reset Procedures >> Tire Pressure Monitor System Reset >> After Wheel Or Pressure Change
April 5, 2026: LEMON Manuals is launched! Read the announcement.

After Wheel Or Pressure Change

  1. Set the tire pressure of all wheels to specified pressure.
  2. With parking brake applied, allow vehicle to stand for 20 minutes (5 minutes after a recognized tire puncture) so that control module enters learning mode.
  3. Drive vehicle at 16 mph (25 km/h) or more. As soon as vehicle reaches this speed, tire pressure sensor IDs are automatically recognized and read by control module.
    NOTE: An acceleration data check also occurs with vehicle speed. This process takes about 7 minutes.
    NOTE: If the standing time is not followed, control module is not in learning mode so system registers a malfunction and can only automatically learn wheel electronics after standing 20 minutes.
scientia non olet · About LEMON Manuals