Overview - Bevel Box

WARNING: This page is about a different variant/trim than selected.

Fig 1: Identifying Bevel Box Overview

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

Bolt
- Tightening specification. Refer to OVERVIEW - DIFFERENTIAL, AWD AND FWD WITH FRONT AXLE DIFFERENTIAL LOCK .
Heat Shield
- For drive axle
Nut
- Quantity: 2 or 3
- Tightening specification. Refer to [For transmission(s) 02E, 02Q, 09M] [For engine(s) CNNA, CCTA, CBFA] Drive Axle Differentiation .
Bolt
- only on bevel box "0CN" for the heat shield at the bevel box
- Tightening specification → Refer to [For transmission(s) 02E, 09M] Driveshaft .
Heat Shield
- For driveshaft
- Only on bevel box "0CN"
Bolt
- Tightening specification → Refer to [For transmission(s) 02E, 09M] Driveshaft .
- Only on bevel box "0CN" for the heat shield at the bevel box
Bevel Box
- Differentiating. Refer to BEVEL BOX, DIFFERENTIATING .
- Removing. Refer to BEVEL BOX, REMOVING .
- Installing. Refer to BEVEL BOX, INSTALLING .
Bolt
- Quantity: 4
- Replace after removing
- Tightening specification. Refer to OVERVIEW - DIFFERENTIAL, AWD AND FWD WITH FRONT AXLE DIFFERENTIAL LOCK .
Transmission Carrier
- There are different versions. For the correct allocation.
Bolt
- Quantity: 2
- Transmission support to bevel box
- Tightening specification and sequence:
- Bevel box "0AV". Refer to Figure
- Bevel box "0CN". Refer to Figure
Bolt
- Quantity: 2
- Transmission support to engine
- Tightening specification and sequence:
- Bevel box "0AV". Refer to Figure
- Bevel box "0CN". Refer to Figure

NOTE:

Pay attention to "bevel box, differentiating". Refer to BEVEL BOX, DIFFERENTIATING .