Accessing The Code For The Electronic Anti-Theft System Using The Vas Tester

WARNING: This page is about a different car, the 2011 Volkswagen CC, 2010 Volkswagen CC, and 2009 Volkswagen CC. However, it is still accessible from the selected car via links, so may be relevant.

Special tools and workshop equipment required

Vehicle Diagnostic Tester
Diagnostic adapter cable VAS 5051/5a or VAS 5051/6a or VAS 5052/3

Select "Guided Functions" or "Guided Fault Finding" in the Vehicle Diagnostic Tester.

After all control modules have been checked:

-- Press the "Go to" button.

-- Select "Functions/Component selection".

-- Select "Body".

-- Select "Electrical Equipment".

-- Select "01 - Systems capable of self-diagnosis".

-- Select "Radio navigation system".

-- Select "Functions".

-- Select and start "radio code inquiry".

An authorization to the system will be requested: Then the operating data, the VIN and the Radio/RNS -RX1- serial number will be automatically read out.

NOTE:

When installing a new radio or a reinstalling a Radio/RNS -RX1- that has not yet been adapted, it is possible that the testing device cannot read the identification number for the Radio/RNS. In this case, the identification number must be entered manually. The serial number can be found on a sticker on the unit and is also stamped into the side of the unit.

Then the radio code will be displayed in the tester.

The anti-theft code must be manually entered into the radio/navigation.