LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Volkswagen >> 2013 >> Routan S >> Repair and Diagnosis >> External Pages >> Different car >> Section 1154 (Vehicle Dynamic Systems) >> Removal And Installation >> Steering Wheel Rotation Sensor >> Removal And Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Removal And Installation

WARNING: This page is about a different car, the 2008 Ford RV Cutaway, 2008 Ford Econoline, 2008 Ford E450 Super Duty, and 2008 Ford Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the steering column opening cover.
  2. Remove the 2 bolts and detach the data link harness retainer.
    3. Fig 1: Data Link Harness Retainer & Bolts
    GF0012331Courtesy of FORD MOTOR CO.
  3. Remove the 4 bolts and the instrument panel LH knee bolster.
    • To install, tighten bolts to 9 Nm (80 lb-in).
  4. Disconnect the steering wheel rotation sensor electrical connector.
  5. Remove the 2 steering wheel rotation sensor bolts.
    • To install, tighten to 1 Nm (9 lb-in).
  6. Remove the steering wheel rotation sensor.
  7. To install, reverse the removal procedure.
    • Calibrate the ABS module. Follow the scan tool directions.
scientia non olet · About LEMON Manuals