Transmission Fluid Level, Checking And Filling: Checking

WARNING: This page is about a different car, the 2014 Volkswagen Golf, 2013 Volkswagen Golf, 2012 Volkswagen Golf, 2011 Volkswagen Golf, and 2010 Volkswagen Golf. However, it is still accessible from the selected car via links, so may be relevant.

-- Turn off the engine.

The transmission fluid temperature must not be more than approximately 30°C (86°F) at the start of the test.

The transmission is not in emergency running mode, and the fluid temperature is not higher than 30°C (86°F).
The vehicle is horizontal
The selector level is in the "P" position.

-- Connect the tester and move through the selections until it is ready for operation. Refer to VEHICLE DIAGNOSTIC TESTER, CONNECTING .

-- Press the right button Guided Functions .

-- Select the vehicle, the transmission and check ATF level .

-- Press the → button.

-- Start the engine.

-- Lift the vehicle.

-- Place a drip tray under the transmission.

-- Press the → button.

If the test temperature is 35 to 45°C (95 to 113°F):

-- Remove the plug from the oil pan.

Fig 1: Identifying ATF Level Plug

Courtesy of VOLKSWAGEN UNITED STATES, INC.

The fluid flows out of the overflow tube.

Fig 2: Identifying Example Of Filler Tube Installed In Transmissions

Courtesy of VOLKSWAGEN UNITED STATES, INC.

If fluid continues to drip out of hole:

The fluid does not need to be topped off.

-- Install and tighten the plug with a new seal to 27 Nm. The level check is now completed.

If no fluid drips out of the hole:

-- Fill with transmission fluid.