C2200-45 - Anti-Lock Brake Module Internal - Program Memory Failure
For a complete wiring diagram, refer to appropriate Wiring Diagram.
- >>When Monitored:<< Ignition on.
- >>Set Condition:<< The Anti-lock Brake System (ABS) Module has detected an internal error.
| Possible Causes |
|---|
| ANTI-LOCK BRAKE SYSTEM (ABS) MODULE |
Test Step 1 - ANTI-LOCK BRAKE SYSTEM (ABS) MODULE INTERNAL CONDITION
- The ABS Module is reporting internal errors.
NOTE:
Before continuing, check the Anti-lock Brake System (ABS) Module harness connector terminals for corrosion, damage, or terminal push out. Repair as necessary.
- Using the schematics as a guide, inspect the wire harness and connectors. Pay particular attention to all Power and Ground circuits.
- Perform any Technical Service Bulletins that may apply.
Were there any problems found?
Yes
- Repair as necessary.
- Perform the ABS Verification Test. Refer to Brake System .
No
- Replace the Anti-lock Brake System (ABS) Module. Refer to Removal and Installation .
- Perform the ABS Verification Test. Refer to Brake System .